@ahmed_ramadan_geo Regarding your questions: 1. It removes the maneuver effect due to the swing of the sensor as well. 2. There are really NO b...

@ahmed_ramadan_geo Hi Ahmed, The remaining noise after compensation is likely from 3 main sources: 1. The intrinsic sensor noise. At 10Hz, ...

@kuldeep You are correct. If the Ethernet software is installed, wifi code doesn't work. You can still connect to wifi. But there is no data communica...

@kuldeep Please refer to our other post: According to your description, most likely the wifi firmware is still running in the dev kit. Please loa...

Hi Peter, this is intentional! We had to do this to discourage spam users.

If the Operating status shows error code of 10 or 11, the dropout issue may be fixed remotely. Please download the file below and follow the instructi...

The Mag Status table can be found on page 8 of the MFAM module user guide, which is inside the USB drive shipped with the MFAM. The user guide can b...

@kuldeep, No, the data streaming is ONLY through the Ethernet port, not the UART5 port. Current instrument software does not support the UART5 streami...

@ellipsis You are welcome! From the front of the front eyelets to the rear of the rear eyelets, it is a little more than 27 inches. So, your CAD readi...

@ellipsis We would recommend the rigid part to be ~ 1m. So with the landing gear, the MagArrow is about 1.5m from the drone.