Information MFAM Development Kit IP Address

The MFAM Development Kit is usually set to a fixed address of 192.168.2.2 (port 1000). The Ethernet port on the Windows PC must also be switched from DHCP to a fixed IP Address mode in order to connect to the Dev Kit. The procedure for doing this is described in the Dev Kit User Guide.

If there are more than one Dev Kits connecting through an Ethernet switch they cannot have the same address. Therefore it is possible to set the Dev Kit IP address to something other than the default.

192.168.2.3 and 192.168.2.4 firmware are included in the USB drive shipped with Dev Kit and can be downloaded here:

https://www.geometrics.com/product/mfam-developer-kit/

For other IPs, please contact Geometrics or reply to this post. You may need to install the Uniflash program from Texas Instruments.