Notifications
Clear all
Search result for: id10=WA 0859 3970 0884 [[HATIGA]] Fee Pasang Paving Grass Block Carport Semarang
Your need of a magnetometer base station like the G-862RBS depends on the objective of the survey. If one is performing a geologic survey to investigate deep structure (exploration for mineral deposits, oil/gas, geology) then the wavelengths of the "target" body are typically “long” (long in meters, therefore long in data acquisition time). The rate at which the Earth's natural magnetic field responds to interaction with the solar wind is also typically many seconds to minutes (diurnal variations). Since the geologic and diurnal variations are of similar wavelengths, a geologic mag survey usually requires a base station. Please read the introductory sections of the Applications Manual for Portable Magnetometers offered on our website for more details.
If you are moving fast (fast in the sense of a brisk walk, ~1m/s) and looking for small targets (UXO, archaeological artifacts, environmental targets like drums, pipes, etc.) then you are “up and over” them in a matter of seconds and typically the earth’s field does not change in this time frame. So there is less need for a base station for these type surveys. Of course, it never hurts to have a base station running and if you are surveying over multiple days, having a reference station will allow easier “block leveling” of multiple day surveys.
It is easy for a healthy, fit person to tow the OhmMapper on flat dry ground or pavement. It is more difficult on Grass or other surfaces where more friction is present. Towing the OhmMapper up hill is, of course, more difficult. The OhmMapper can be towed with a vehicle. However, a tow adaptor is required that will release the array in case a receiver cable is snagged on something in the tow path. A connector can be broken if it is snagged and towed by a vehicle but the tow adaptor is not required when it is manually towed because a person cannot exert enough force to break the connector under normal operating conditions.
Our seismographs do not require periodic calibrations in that they do not
have any adjustable parameters. With that being said, we do recommend
that they are checked for performance and routine maintenance to include
intensive analog tests of the acquisition circuitry. A reasonable interval
would be around every 5 years for normal usage.
During these tests we verify that the seismograph analog performance
meets our specifications by using a seismic test system. This system
incorporates a standard reference oscillator and precision resistor
networks to inject known signals into the seismograph. We then use
algorithms in our software to calculate the response and performance of
the analog circuits.
This "performance test" is run whenever we receive an instrument in for
repair or evaluation. Some of our customers do prefer to have the performance of their instrument checked on a periodic basis especially if they are
required by their clients, for example the NRC. We offer these nontraceable
recertification’s to include a calibration certificate and test results
for a Fee of $300.
If you would like us to perform performance verifications and a system
evaluation please reserve an RMA and obtain shipping instructions.