For a low-noise MagArrow, how to check whether it is set to the low-noise mode or the low-heading mode? - Software https://www.geometrics.com/community/magarrow-software/for-a-low-noise-magarrow-how-to-check-whether-it-is-set-to-the-low-noise-mode-or-the-low-heading-mode/ Geometrics Discussion Board en-US Mon, 08 Jun 2026 05:02:44 +0000 wpForo 60 For a low-noise MagArrow, how to check whether it is set to the low-noise mode or the low-heading mode? https://www.geometrics.com/community/magarrow-software/for-a-low-noise-magarrow-how-to-check-whether-it-is-set-to-the-low-noise-mode-or-the-low-heading-mode/#post-1179 Fri, 09 Aug 2024 16:47:38 +0000 If you purchase a low-noise MagArrow (I or II), the factory default is the low-noise mode.

You can also look up the current running mode by loading the following website (in Instrument Status) after connecting to the MagArrow:

192.168.1.1/systemtest.cgi

To switch to a different mode, please download the special software below and follow the instructions in the readme file:

86

Please note that even in the low-noise mode, the heading effect is typically only ~20% worse than that in the low-heading mode. For most applications, you don't need to switch to the low-heading mode.

]]> Software Rui Zhang https://www.geometrics.com/community/magarrow-software/for-a-low-noise-magarrow-how-to-check-whether-it-is-set-to-the-low-noise-mode-or-the-low-heading-mode/#post-1179